Cutting data calculator

Spindle speed follows from the cutting speed and diameter: n = 1000·Vc / (π·D). Milling feed is Vf = n·z·fz, drilling and turning feed is Vf = n·f. Enter the values and the result updates at once.

Spindle speed n
— rpm
Feed rate Vf
— mm/min
Removal rate Q
— cm³/min

Take cutting speed and feed from the tool maker’s recommendations for your material; start low and check the chips and the load.

Formulas

  • Spindle speed: n = 1000 · Vc / (π · D), rpm. Vc — cutting speed, m/min; D — tool diameter, workpiece diameter in turning, mm.
  • Cutting speed from rpm: Vc = π · D · n / 1000, m/min.
  • Milling feed: Vf = n · z · fz, mm/min; z — flutes, fz — feed per tooth, mm.
  • Drilling and turning feed: Vf = n · f, mm/min; f — feed per revolution, mm.
  • Removal rate in milling: Q = ap · ae · Vf / 1000, cm³/min; ap — depth, ae — width of cut, mm.

FAQ

How to calculate end mill rpm?
n = 1000 · Vc / (π · D). A 10 mm end mill at 120 m/min: 1000 · 120 / (3.14 · 10) ≈ 3820 rpm.
How to calculate the milling feed rate?
Vf = n · z · fz. A 4-flute mill at 3820 rpm and 0.05 mm per tooth: 3820 · 4 · 0.05 = 764 mm/min.
How to calculate the drilling feed?
Vf = n · f, f being the feed per revolution. A drill at 2000 rpm and 0.15 mm/rev: 2000 · 0.15 = 300 mm/min.
Where do cutting speed and feed come from?
From the tool maker’s catalog: they depend on the grade, coating and workpiece material. Start at the low end.

Tap drill chart →

Cutting data calculator: milling, drilling, turning | ТехПромРез